How to glue vinyl wallpaper

In fact, the gluing of all kinds of wallpaper isidentical, but it will not be correct to apply old norms to new types of materials, for example, to vinyl wallpaper. This can lead to their spoilage, which is highly undesirable. So, if you are worried about how to glue vinyl wallpaper, then it will be considered exactly it.

Before proceeding with this operation,you need to make sure that the wallpaper received the required article, and also that the rolls have a single lot number. It is worth sticking two or three strips, after which carefully check them for defects. In case of a marriage, immediately contact the supplier, and the work must be stopped.

If we consider the question of how to gluevinyl wallpaper, it should be said that at the first stage, you need to prepare the walls. They should be made smooth, smooth, clean and dry, you should get rid of flaking paint, signs of mold, grease, and also from old glue.

If the walls have been plastered recently, it is important to givedry them, and then apply a primer coating. An important condition is the priming of all walls before the start of the gluing. As a primer, water-based paint is not at all suitable.

Vinyl wallpaper: how to glue

Now you should prepare the bands. It is done this way: you need to cut off two canvases that are equal to the height of the ceiling in the room, while taking into account the fit of the pattern and allowances of 5-10 centimeters to each of the strips. The strip should be cut off from the roll only after the pattern is adjusted on the sheet until it is completely matched. Each cut strip should be marked in pencil in order, so that later there is no confusion.

And now we came very close to the question of howglue vinyl wallpaper. Stripes must be glued strictly in the order in which they were cut off from the roll. The first must be glued on the plumb line. Trimming the wallpaper on the floor and ceiling should be done with a spatula using a sharp enough knife. Glue should not fall on the joints of wallpaper. If it hits the surface of the sheets, it must be removed immediately with clean water and a sponge. The wallpaper should not be rubbed against the edges, since the dried glue can damage their surface. It is worth immediately getting rid of it if it got on the platbands and plinth. Glue should be applied to cut sheets. This concerns the issue of "how to glue vinyl wallpaper on paper basis." However, there is another kind of basis - non-woven. In this case, the glue should be evenly applied to the wall surface, after which it is possible to carry out the gluing.

When the process is completed, you need to make sure thatthe wallpaper is held firmly on the surface. It is worth saying that the described rules can only be called recommendatory, since they do not take into account all the nuances and features of the work. If you trust experts in the question "how to glue vinyl wallpaper", then they will take full responsibility. In the event that you have undertaken your work independently, then you should do everything with the utmost care to avoid negative consequences.