If you do not know how to make a warm floor yourhands, in this article you can find some useful tips. So, first we will understand how he is. The design can be water or electric. The first option works at the expense of a centralized heating system, and the second - from the network. In order to make a water structure, it is necessary to choose pipes of small diameter made of metal-plastic, which can withstand a sufficiently high temperature. In the second case, you will need a high-quality heating cable.
After it dries, you can carry outprocedure for laying the elements of the warm floor. Modern stowage technology recommends the use of special aluminum guide plates with pre-prepared channels, into which the pipe (cable) will be mounted.
If you have figured out how to make a warm floorown hands with the use of water pipes, then the technology of laying the electrical cable has its own characteristics. So, to begin with, you should choose the right material: single-core or double-core. The first option is the most acceptable.
How to make electric floor heating without errors? First determine the power of the cable, although it can be controlled by a thermostat. In addition, sensors that determine the heating temperature will be connected to the system. Preparing the foundation will not take long. First you need to make the alignment of the base surface of the rough concrete screed, and then lay on its surface waterproofing film. The next step is laying the heating element. To fix it, you can use special guide plates with grooves. In this case, the base area and the laying step are taken into account. In addition, it is necessary to remember some rules of arrangement of the system. For example, it is impossible for cable parts to intersect, the minimum distance between sections should be 7 cm, the bend should not have a small radius. In addition, the heating element can not be laid under furniture or household appliances. If you want to further insulate your floor, you should not mount the cable directly on the material used. It must be isolated.
The next step of the installation involvesconnection of the structure to the network, connection of the thermostat and sensors. All connections must be well sealed and insulated (as well as the cable itself). For this you can buy clamping terminals. If everything is done correctly and during the verification of the problems with the operation of the system did not arise, it is possible to fill the concrete screed and laying the finishing.
If you do not know how to make a wooden floor warm, then after reading the article, you will have an idea about it.