How to get right from the place of the car to a newcomer?
The first difficulty faced bybeginning car enthusiasts, this is a smooth starting of the car from the place. A little bit not so pressed the pedal, and everything - the car stalls or will go jerky. But all this does not matter, because every experienced car enthusiast in his time just learned to drive. And today we will take a closer look at this issue and find out how to get right from the spot on the car.
What do I need to do?
You have three pedals and a gearshift knob. On cars with "automatic" only two: gas and brake - and to learn there, to be honest, there is nothing. In the case of automatic transmission, electronics makes everything for you, so the question "how to start a car and go" there is not so acute. Where it is more difficult to master the skill of driving with a mechanical box. Therefore, we will consider it. So, how to get right from the place on the car? First, before turning the ignition key, you need to assess the situation: if the car is on a slope, while the first gear is engaged, there is a risk that if it does not work correctly, it will go or roll off the hill. So that neither of them happens, we press the brake and squeeze the clutch pedal.
When the car started, press again on the extremethe left pedal (in this case, if the car is on a slope, do not release the brake) and translate the gear lever into the desired position. It is not recommended to start on the second or worse third gear. Firstly, this is a big load on the engine and gearbox, and secondly, the car simply does not go or immediately stall.
Smoothly release the clutch pedal and with the samepress the gas pressure until the arrow of the tachometer rises to the green scale. So, you felt that the car was slowly moving. To further it did not stall, continue to vary the two pedals with the same effort. At the same time, gas press a little more confidently, but not in the floor, so that the car does not crash into the nearest obstacle. When the clutch is fully released, continue the course until the engine speed requires switching to an increased gear. Do not be afraid to put pressure on the gas pedal due to the fact that the car is now "flying". Slowly press it, and everything will be fine. With experience, you will develop this skill.
Switch gears
The question "how to get right from themachine "we have already considered, now we proceed to how to properly switch gears. In principle, there is nothing complicated, and the algorithm of action is very similar. Before you go by car in the second gear, remember that first you need to wait until the engine will gain the necessary speed. When the arrow of the tachometer comes out of the green scale, we start to switch over to the switch. First, squeeze the clutch, translate for one second the gearshift lever to the neutral position, after which the scheme includes the second. The second action is necessary in order to reduce the load on the transmission gears when switching speeds. Now, as in the first case, release the clutch and press on the gas. Do the same when switching the subsequent speeds.
Conclusion
So, we found out the basic nuances when starting the car and switching speeds. At this stage, the question "how to get right from the spot on the machine" can be considered closed.
